Questions & Answers for: Lexmark motor shaft

making a noise when the paper is fed thru to be printed on, it is making a noise. like a rumbling noise. just when it is feeding the paper thru, then it stops. it still prints. this is a new noise, it

Paper will not feed through though the carts do pass WHYFMR6P4WXK My printer did the same thing, paper would not feed through so my son and i took it all apart and found the feed driver gear to be ...

PRINTER CARRIER STALLS printer carrier stalls for obstruction and there is no obstruction x4875 lexmark Check printer drive belt for worn out teeth and also ensure that the printer shaft is free of ...

printer thinks there is a paper jam, but there is no paper jam. Can you help? Paper will not feed. Hello sir; First, check carefully go through entire paper path make sure there have nothing stuck ...

x215 paper pickup roller needs to be replaced My experience is paper pickup rubber is old, shrunk and dried out.  You can replace the entire roller assembly (including shaft) or the roller only ...

roller bars don't seem to be feeding the paper through I found a split 50 tooth gear on the drive roller shaft, and instead of turning the roller shaft, it was slipping, due to the split plastic gear,

...motor that drives the belt. When the landing pad is to the left most travel, it should be down out of the way of the cartrige movement. I had to remove the shuttle guide shaft to move the ink shuttle ...

What does "Hardware Error 0502" mean? What does "Hardware Error 0502" mean? The shaft that the ink cartridges travel back and forth on get buildup on it. If you clean it, your problem should

...However there is no power up process. No fans come on, nothing is displayed on operator panel. No motors runs. This unit was working fine just before we replaced a gear for to interface with the ...

...shaft. 4. Motor drive belt - tray drive belt. Check the DC motor drive belt for damage. Make sure the belt is tracking correctly on the drive pulley, idler pulley, and motor pulley. Check the tray ...