Questions & Answers for: motor shaft Dishwashers

...motor shaft loose. i am trying to turn the shaft in the clockwise direction and with an adjustable holding the rear shaft, (which on my unit is plastic) and the plastic cover on the rear of the shaft ...

...motor shaft. Thanks Rick     Here is what we do:    If possible, we take the whole thing out; motor and fan blades together. Then we sand down the exposed part of the shaft. ...

...motor shaft.Try spinning the auger shaft over the motor shaft. The auger shaft should spin freely over the motor shaft without binding.If the auger binds, loosen the 7/16th inch bolts on the motor ...

...motor shaft,#7. the motor (3 screws, small),#8. the top half of the motor (4 large screws)#9. found black, dry hard carbon residue in the bottom motor bearing#10. rinsed with 5w-30, Mobil One ...

...shaft seal? open & dismantle pump from motor. Some will have thru bolt motors all the way thru the motor, heads of bolts are (4 each) visible & accessible at back of motor. Loosen these & ...

motor and you can use whatever tool required to keep the shaft from spinning. Once you are able to lock the shaft, you can read the impeller... Note* some styles will have a screw in the middle of the

...motor shaft.Try spinning the auger shaft over the motor shaft. The auger shaft should spin freely over the motor shaft without binding.If the auger binds, loosen the 7/16th inch bolts on the motor ...

...motor shaft. Try spinning the auger shaft over the motor shaft. The auger shaft should spin freely over the motor shaft without binding. If the auger binds, loosen the 7/16th inch bolts on the motor ...

...motor shaft. Try spinning the auger shaft over the motor shaft. The auger shaft should spin freely over the motor shaft without binding. If the auger binds, loosen the 7/16th inch bolts on the motor ...

...motor shaft. I used needle nose pliers to pry whisk shaft away from motor shaft and it separated easily. Ordered D.C. Motor from china on ebay. 21 mm diameter case. 2mm shaft width. Motor was .99 ...