Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
motor shaft while removing the impeller. The answer I got wasn't relevent. No flat spot on the shaft at the rear of the motor shaft either. I tried some vice scripts, but the impeller is really frozen
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...motor shaft. In my case the impeller was so caked onto the shaft with rust that we could not loosen it. We broke the impeller and still could not unscrew it. The screwdriver keeps jumping out of the ...
Question about Pump Part Seal Set Ps1000 Cd 319 3100b/Ps 1000
to replace my out put seal on my hot tub pump. i need help getting the impropell off the motor shaft? Take the pump to a motor shop. there is often shaft damage...and then bearing and bushing damage..
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...motor shaft has rusted in place. Remove the pump and try to free the motor shaft. If there is rust around the shaft spray in some wd-40 and let it sit a while. At the far end of the pump is small cap ...
Question about Executive 56 Spa Pump 3hp 2" 2spd 37212211 ()
...shaft cap at the rear of the MOTOR. (on the electrical end) this should come out with just a flathead screwdriver. (if it bends a little its no big deal.) Lock onto the shaft end we just uncovered ...
motor shaft is in good enough condition to allow the new seal to work properly. If too much shaft material has rotted away the new seal will leak soon after it is installed; you would need a new motor
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...motor shaft. In my case the impeller was so caked onto the shaft with rust that we could not loosen it. We broke the impeller and still could not unscrew it. The screwdriver keeps jumping out of the ...
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...motor shaft. In my case the impeller was so caked onto the shaft with rust that we could not loosen it. We broke the impeller and still could not unscrew it. The screwdriver keeps jumping out of the ...
Question about Spa Pump Executive 56 Frame 4hp Dual Speed 2" Intake 2" Discharge
...motor shaft so even though the motor turns the impeller is not. Replacing the impeller and the seal are not to hard but you may want a shop to do it if you are not familiar with seal replacement. ...
Question about Executive 56 Spa Pump 3hp 2" 2spd 37212211 ()
remove wet end shaft on a 56 executive spa motor How to take d center shaft out of a 56 executive spa motor if was leaking it ruined bearings in motor replace whole unit
Usually answered in minutes!
44 Questions
5 Questions
1 Questions
