...motor shaft, note where they go for reinstall. there may be a lock screw in the top right clip. swing pump to the left and use a string or bread bag tie to hold it out of the way. remove spring clips ...
Kenmore Washer No Spin >> Motor problem I removed the pump and motor. I then placed the motor on the ground, reconnected to power, jumpered the lid switch, turned to spin cycle, motor just hums and ...
...motor shaft, one is attached to the gearbox input shaft and the rubber ring mates them together, the motor shaft coupling collapses often, the coupling is ~$16-$25 depending on the parts sales place. ...
motor shaft. I know it's a reverse thread, but how do I get the fan blade off without destroying it. Also, there is a retaining clip on the rear of the motor that holds the rear bearing in it's saddle
Question about 82822 Electric Dryer
...motor shaft that is preventing the pump from being removed? best solution remove screws holding clamps to motor remove motor wire and clips take complete assembly of and try tapping pump off with ...
...matches up with the metal ring on the new coupler (you may have noticed the old one had no ring) and tap it LIGHTLY to get it to seat on the motor shaft and tranny shaft. Hope this helps
...motor? if you have (visegrips) use one on the shaft, and one on the fan shaft, use a little penetrating oil on the shaft, move both part in opposite directions, this should loosen up the fan from the ...
Question about 53542 / 53544 Side by Side Refrigerator
...motor shaft. Here is how it works: the motor has a set of starter coils, and a set of running coils. There is a momentum actuated sliding switch on the shaft. When the motor starts from the normal ...
...motor shaft and one on the transmission shaft. There is a rubber coupler that connects the two. Replace which ever white plastic piece is broken, or the rubber piece if that is it. Make sure not to ...
Question about Series 70 80 90 PN281798 Dryer Motor
...motor shaft may be gummed up with lint you would have to take out the motor and check out the spinning shaft weights to make sure there clean and move to disconnect the switch when the motor starts. ...
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions