motor and step pulley. It is a 3 speed. It has a 6'' pulley directly attached to 14'' bandsaw lower wheel. A V belt is then connected directly to a (4 position) step pulley. This 6'' pulley is connect
...pulley on motor with 4 3/4 pulley on arbor gets me very close..prior post on this..however realize buff wheel wears down speed increases ..no good..so my question would be instead of a variable pitch ...
Question about Neptune FAV6800AW Top Load Washer
...motor pulley not the idler pulley but the one that is on the motor. It does not show in the drawing a part for this pulley. I went to distributor and the got a motor out for this model and it shows ...
Question about Rand Type 30 Reciprocating Air Compressor 5 Hp, 80 Gallon, 230 Volt 3 Phase, Model# 2340N5
...pulley at the motor the higher cfm produced but more amps used. Motor speed x pulley dia. divided by compressor pulley dia. To obtain more efficiency and highest cfm you will need 3 phase. Good place ...
Question about Rand Type 30 Reciprocating Air Compressor 5 Hp, 80 Gallon, 230 Volt 3 Phase, Model# 2340N5
...whole motor. Here is a link to the breakdown, the motor is $143.00 Good luck, best regards. http://www.reliableparts.com/models/140134/305019# appliance parts pro has the motor pulley 5$ ...
...motor pulley by tapping it into position. remove motor belt by loosing motor. Drill 1/8 hole through the pulley and roller. Take a larger drill bit and countersink the pulley hole so the head of a ...
...MOTOR PULLEY WHILE ROATING LARGE PULLEY WALKING BELT ONTO SMALL PULLEY OR LOSEN MOTOR BRACKET PAY ATTENTION TO LOCATION OF MOTOR BRACKET ALIGNMENT PUT BELT ON BOTH PULLEYS PUSH MOTOR TILL BELT IS ...
...drive belt for damage. Make sure the belt is tracking correctly on the drive pulley, idler pulley, and motor pulley. Check the tray drive belt for damage. Make sure the belt is tracking correctly ...
...motor pulley and smallest drill head pulley. It runs slow and overheats in 10-15 seconds and the internal overload trips. If u run the motor pulley on it's 2 smaller diameters, it seems to run just ...
Question about X646e Laser Printer
...a spare motor lying around, 3 phase, 3420 RPM, can I use this faster motor if I size down the motor pulley to get the same speed at the pump? Thank you If you reduce the supply pulley diameter,
Usually answered in minutes!
386 Questions
103 Questions
81 Questions
63 Questions