...for appx 5 minutes before starting it. Is this normal or a problem? that is strange the oil pressure only builds up when the motor is running i would be wary if it was me buying it hope this helps ...
...lift it up then disconnect linkage should be four bolts holding on two clamps then unplug the motor then remove screws then put new one on in reverse order i would oil linkage during ...
...oil filter, the distributor cap ( don'tunplug the wires) and the bolts from the motor mounts. With this done you should be able to jack up the engine with a block under the oil pan and a hydraulic ...
...the case, there should be a cap type dipstick instead of the standard "hook". There are 6 different motors (8 including variations) for your truck so no manual has the exact location of the oil cap. ...
...of deisel fuel to motor let motor run for approx.15 minutes.drain motor oil and refill with 20/50 weight motor oil that should raise oil pressure,if it doesnt you probable have internal engine
...Silverado 1500 w/4 wheel drive take? My son wants to change the oil. 4 1/2 to 5, including the filter. Pour in 4, start the motor and run for a minute or two, shut off and recheck oil. Add as
...switch go the oil pressure swicth or oil sending unit is on the bottom of the motor near the oil pan. It will have a wire attached to the end of it. It easily screws out to replace with a new
...with rpm increase if you have no engine noise your oil sender is probably faulty its rare for these motors to fail even with very high ...
...oil pressure and a little knock when starts It is a 350ci motor with low miles . Iherd all these motors do that Worn bearing caused by a defective oil pump or low pressure due to leakage around the ...
...oil pan in a 1990 chevrolet c1500 5.7L. Does anyone have any suggestions on how to do this? You'll need to remove the bolts on the motor mounts and jack up the front of the engine to get enough ...
Usually answered in minutes!
584 Questions
420 Questions
403 Questions
331 Questions
284 Questions
