Questions & Answers for: mono amp 4 ohm

Ad

Question about C12-4 Car Subwoofer

1 Answer

...mono amp with a high enough 4-ohm power rating, it would run cooler and might last longer than a 2-channel amp with comparable power. When looking at mono amps, you'll find their highest power output ...

Ad

Question about C12-4 Car Subwoofer

1 Answer

...amp. The recommended minimum impedance was 4 ohms mono/2 ohms stereo. I had it wired up 2 ohms mono rear and 1.5 ohms stereo front and even once had all 4 channels bridged at 1.5 ohms mono/per side ...

Ad

Question about MRD-M605 - V12 MONO AMP 600WX1 RMS 2 OHM Car Audio Amplifier

1 Answer

...mono amp. I want to push 2 kicker l7 10'' dvc 4 ohm solo barics. Is there any way to run one sub to each amp ? and if so how i would i go about doing this? Thanks No, thats what you don't what to do. ...

Question about KAC-8104D Car Audio Amplifier

1 Answer

AMP

...mono amp to ''2'' V12D4 12-in 600 watt duel voice coil 4 ohm, if their is a diagram. Would i parell run them? That amplifier is only stable to 2 ohms. You will only be able to use one Dual 4 ohm ...

...mono block how do i get the most sound? without overloadin my amp? Hi mate very nice amp you got there here is the specs for it Model: MA Audio HK401SX Hard Kore Series 1800 Watt 1 Channel High ...

Question about HK401SX Car Audio Amplifier

1 Answer

...would you hook a alpine r12 dual 4 ohm sub to sony xm-1s mono amp in parallel get both positives and both negatives together and wiring them to amp for a 2 ohm load. the sony xm1s is a 2 ohm mono ...

Question about (SLH-T7512X2-A) Car Speaker

1 Answer

...mono amp? how can i bridge a mtx 9500 sub using a mono amp? You cant bridge it to the MONO AMP . You can only bridge subs & speakers to 2 CH & 4 CH AMPS that are bridgeable. Because if it ...

Question about Solo-Baric L5 Car Subwoofer

1 Answer

...amp to 1x1000W will the power distribute evenly between both speakers? Option 1 (parallel) = 2 ohm load Speakers wired in parallel Recommended Amplifier: Stable at 2 or 1 ohm mono Option 2 (series) = ...

Question about CVR12 Car Subwoofer

1 Answer

amp Here are a couple of diagrams 2+4 ohm dual voice coil wiring. Option 1 (parallel/parallel) = 1 ohm load Voice coils wired in parallel, speakers wired in parallel Recommended Amplifier: Stable at 1

amp. 55 watt x2 @ 2ohm. 110 watt x 1 Bridged I assume at 4 ohm. Manual does not specify. It can run 2 ohm in stereo mode but is unclear on mono impedance requirement. It can run 4 ohm mono at 110 watt

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

Marvin
Marvin

Level 3 Expert

85231 Answers

The Knight
The Knight

Level 3 Expert

76287 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...