...mixture screw. It's on the backside of the float bowl towards the engine. Take a small drill bit and carefully drill through this plug. Do not drill too deeply or you will damage the idle mixture ...
mixture adjusting screw, do so. Be careful not to damage the screw as they are not available seperately from Harley. This will enrichen the low speed mixture just a bit. You can also remove the needle
...mixture screw but still no luck.. would be good if anyone has any other ideas... Ok, it sounds like you're either not getting fuel though the jets in the carb or you've got a bad vacuum leak. ...
...mixture screw inside a carb body lug that may or may not be plugged with an aluminum cap that's about 3/16" thick. This cap can be drilled out to acess the air/fuel mixture screw. Turning screw ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions