...mixer seems to be stuck Motor turns on but blade doesn't turn-feels stiff. It says in the manual to soak it in very hot water for 10-20 minutes, then try again. This should free trapped food from the ...
...stuck on KA stand mixer cannot get blade off!! Using one of the bowls, filled it with hot water up to the shaft and where the paddle is hooked up. Using a cotton cloth, wrap it around the paddle and ...
...mixer had the flat beater blade stuck onto the turning drive-shaft and would not move up, down, or sideways - like it was tack welded onto the drive-shaft. I tried all the initial recommended steps: ...
...is not working as the grinder was stuck and when I ran the mixer the small wings snapped the blade of the jar got jamed, you have to remove the jar shaft and lubricat with any oil and refix it ...
Question about K45SS Classic Stand Mixer
blades ?stick? when you try to remove them. Also check the blade and see if there might be some additional scouring inside the attachment well where the groove pin contacts the blade when you mount or
...stuck-can't remove for cleaning Yes they can be tricky! The blade or dough blade/beater will always have this problem. I dont know of a "manufactured" way to remove this. However a flat screw driver ...
...blades is stuck and I can't engage the release Make sure your Beater can slip in and out of the Beater Shaft easily. Do not force the beater onto the Shaft if the shaft is bent. If it cannot be ...
blades stuck CRC and wriggling, twisting, pushing and grunting. Then when it's off clean out the hole and shine the shaft. Try and polish the hole without making it bigger, food builds up on the ...
...mixer blade stuck Unfortunately, this not an uncommon problem. There is some substance "gluing" the beater in place. Try using some rubbing alcohol where the shaft enters the beater and letting it ...
Question about KITCHEN AID 5 Quart Artisan Series Stand Mixer
stuck in shaft Get some CRC around the shaft and into the beater hole and wriggle it about until it comes free. Rasp the build up in the beater hole out with a round file and clean up the shaft on the
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions