Questions & Answers for: mitutoyo origin button

...Mitutoyo digital micrometer that I just changed the battery in. It hasn't been used in several years, I put my caliper battery in and it worked fine a few days ago. Now I put in the new battery and ...

...Mitutoyo digital vernier 200mm Code 500-197, model CD-8"CS. I replaced the battery then turned it on ,the numbers on the screen would not absolute all sorts of numbers were coming out, I pressed and ...

...MITUTOYO 6 INCH ELECTRONIC CALIPERS,MODEL # CD-6 CS. IT NO LONGER CAN SET ITSELF TO ZERO WHEN THE JAWS ARE CLOSED AND IN THE ZERO POSITION. PRESSING THE ZERO ABS CODE FOR 2 SECONDS AND THE ORIGIN ...

...origin button for greater than 1 second. You may need to use a point tool to push the button all the way down. thanks for the post (just ran into the same issue, now fixed) ...

...this problem. Cheers. There should be a zero reset button to re zero it for accuracy. Close the jaws - reset - start again. Push slowly &Prest small origin button on upper right corner of your ...

origin button i get a blinking "P" above the number readout. when i press it again it starts counting up and then rolls over and keeps counting all on its own. if i turn the dial during this

...mitutoyo micrometer reads E--o5 i have replaced battery and cant make it go away? No.293-766-10 made in Japan I had this problem in the past. I tried all of these fixes but can't remember which one ...