belt how do i change the belt on the bagless eureka boss widetrack? Turn vac over, take out 4 to 5 screws and the top cover will come off. The belt is a cogged belt #72393 and goes between the brush ...
fantom twister 500DX Wheel came off. There may be a piece missing. Nothing to screw the wheel into. Take off the bottom plate (where you would access the belt). Put the wheel back on, put the screw ...
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
...screws from the handle. I still cannot get it apart to get to the upper end of the hose. I've read the posts that say it's tight, but there's no way I can get to it. I'm too far into this to call a ...
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
...screws. one screw adjusts tension on the spring .. the bobbin thread goes under that spring when it is properly threaded .. if the screw is loose or missing then replace the screw or tighten it a ...
...now my needle won't stay in. When I tighten the needle clamp screw, the needle slips out. Am I missing a part on the end of the needle clamp screw? I've had this happen a few times. It's usually ...
screws missing for end of filter Please check your manual for screw replacement guide
...screws at the rear but there's no way that i can see to access them from underneath. What am I missing? Thanks for your help! I have an F7427-900 but try taking a flat headed screw driver to the ...
Question about V1 SteamVac SpinScrub Vacuum
...screws. I can't see where to open the cover to search for a place where the screw came from. Please advise. If the screw has no head it may be a stray screw that doesn't belong there. Even if ...
Question about V1 SteamVac SpinScrub Vacuum
My bissell 1867-8 steam mop is missing a screw out of the base and when I tries using it today the steam was shooting out of the hole where the screw is missing. Any help? Take one of the other out ...
Hoover hurricane strip down How do I get to the cable termination as it appears to have pulled out. I have taken out screws but still can't get in! Use a flat screw driver and try to pry open a bit ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions