Questions & Answers for: Mitsubishi miss alignment

...it to the repairman. 1. Check for no 8.4 volts DC at pin 3 of PC9A10 on the Power PCB, if low or missing replace PC9A10 part # 268P058020. 2. LED does not blink at plug in. Check for 3.3-volts DC ...

...miss it terribly. I have a WT-42315 Mitsubishi, it appears to have a similar problem. Will come and go. It looks like ghosting with red and green not in alignment. I can turn TV off and then back on ...

replaced headgasket now car wont start. i replaced the headgasket on a 2001 mitsubishi eclipse 2.4. now the car sounds like it wants to start but it wont completely crank over. Am I missing something?

...wrong please help Have the timing checked , you may need a new timing belt if its worn out or miss aligned nothing will fix this problem but a new belt .. so have that checked . It was not ...

...the convergence amps. This set uses two STK 392-110 Sanyo amps mounted on a heat sink and hard to miss. They're a 40 pin ic about the size of a half pack of cigarettes. It has also been my ...

...that with the crank at TDC, the both balance shaft is in the right place (this is what the mechanic missed doing), AND the oil pump is also aligned. Should take about 1.5h. To check, start the engine ...

...is close, then get distorted at bottom and left and right - try IC convergence chip AGAIN, or am I missing something? The most likely cause is shorted convergence chips and possibly a few pico

...green convergence Mitsubishi Medallion Model WS73411 - The green convergence adjustment option is missing on the menu options. I am only able to adjust the red and blue. Any ideas on how I can ...

...to shake on the road. Check for tires that are out of balance, a tire that has a bubble, or a tire missing a weight. Also check the alignment of the front

Why is picture blurry? I recently replaced the DLP chip to take care of the white/black dead pixel issue, and it worked perfectly! However, now, the picture is blurry, although it's definitely not ...