Questions & Answers for: microwave door falling

microwave serial # xr2004675 superba heating food - explosion while in heating process- open door - door heavy - small curved piece falls out should we use? me thinks that thou needs a repair man, no?

...door to my microwave it disconnects from the top and subsequently falls off. Any ideas I would think your door hinge has come loose, or the door may be cracked. This should be repaired before the ...

...microwave door spring broke. How do I replace it? Remove the front panel by removing the screws located on the inside of the door (note hold door inplace, since it is heavy and will fall out after ...

...microwave oven door has fallen down. New Whirlpool over the oven microwave. I can see the insulation through the glass. Tried to lightly tap the door to make it fall down but that does not work. I ...

...Microwave. The door was damaged by a grease fire and now the front glass is trying to fall out. I need a door for model #MHE14XMB-4. Any suggestions where to get it and how to install it. I fixed the ...

...door firmly to the microwave, tighten the door hinge. Replace the top hinge. (On some units, both hinges need to be installed at the same time. Use masking tape to hold the lower hinge - makes it ...

...door or new microwave? Best is to see if a door can be sourced from an old set , as you can get one swapped from a scrapped oven. I don't think buying a new one is worth as a recent model will cost ...

J KP85W0D1WW microwave door liner on inside is falling out. Is it possible to replace door? yes you can replace the door assembly,but it will be as much or more than just replacing the entire unit

...do I fix my microwave door latch? It will not allow the door to close. Need to have model for exact fix but door may just have a spring fall off inside door inner panel snaps off you will see the ...

...microwave door is sagging and about to fall off I appreciate your post, Wayne! From my understanding your Frigidaire microwave door is sagging and about to fall off. This could be an issue with your ...