Questions & Answers for: microcomputer

Ad

Question about VR-605 Receiver

1 Answer

back side to make sure the switch is set to 110-120v. once this is done, you will need to reset the microcomputer. here is the procedure. The microcomputer may malfunction (unit cannot be operated, or

Ad

Question about KSBP25FKSS Side by Side Refrigerator

2 Answers

...Hi, there is no reset switch. The original fan was not the culprit. The culprit will be the microcomputer(PCB). This board routes the start signal, and power to the fans and compressor unit. ...

Ad

Question about KSBP25FKSS Side by Side Refrigerator

1 Answer

turned my micowave on it ran for about 5 seconds then stop and showed a display error of f7 Hello : Microcomputer board failure . You need to change the microcomputer board. good luck . please rate

Question about HE2 Plus Front Load Washer

1 Answer

...problem? Error code F28 indicates that one of the below part is bad Motor Control Unit (8540135) Microcomputer Machine Control Unit (8540788) If you find either the MCU or the CCU(Microcomputer ...

Question about Duet GHW9150P Front Load Washer

1 Answer

...f28 Hi, the error code F28 means one or both of these parts are bad. Motor Control Unit (8540135) Microcomputer Machine Control Unit (8540788) It would be a good idea to order both, as both ...

Printer character very small , how to character normal A character set is presented with which unscaled 2D molecular structural diagrams can be constructed. A minimal subset has been implemented in ...

Question about HE2 Plus Front Load Washer

1 Answer

...or get all water out of clothes ok the f-28 means on of these parts are bad,, motor control unit or microcomputer control unit,,, f-29 is the door lock i would start with the microcomputer control ...

Question about HE2 Plus Front Load Washer

1 Answer

...be a huge amount of bad luck. The microwave is only 16 months old. The model is GH5184XPB-7 Hi, F7 Microcomputer Board Failure: Change the microcomputer board. You will have to replace this board ...

where is the microcomputer located in the jvc rx6030v? I see the code pop up just before the unit shuts down....dsp micom ng HelloThe microcomputer, otherwise called as system control can be located ...

Help finding what board the main microcomputer is located on Hello, just looking to see if someone can help me locate the main microcomputer in my pioneer pdp-r04u.the problem I have with my receiver ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

Ekse

Level 3 Expert

13434 Answers

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

The Knight
The Knight

Level 3 Expert

76204 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...