Questions & Answers for: Ford F-150 metal gear

Shifts hard and jerks The shifting in every gear is really rough and jerks the truck alot. What is the problem? replace the vehicle speed sensor,yours probably has metal shavings,or dirt stuck to it.

drain the transmission case remove any metal debris; remove the gear set and, replace the syncro...the fork can probably be re-straightened use clean, new case oil when you reassemble the transmission

Passenger side window will not raise. Moter runs fine. I'm not sure how to get at the gears. the window is out of its metal plate

...probably have to drain the fluid and open up the cover. Check the magnet on the bottom for any metal shavings. You may have lost a bearing or some of your gears might just be worn out. While in ...

...metal filings in it maybe consistant with normal wear and bad axles and axle brgs also backlash appears to be normal with amount of miles ( 150k) flushed diff and added mobil synth lube compatibale ...

...noticed a small amount of fine metal on the drain magnet. does it lock up in any gear? sounds like blocking rings trying to stick, what type oil did you put in it? should take auto transmission ...

...gear metal in the oil Depending on how many miles are on it since the gear oil has been changed, some metal will be normal. If the differntial wasn't whinning or making noise i would drain it, ...

just a small gear on the motor and a long metal gear an the regulator. They are riveted in,if the door panel cracked or a rivet came loose the gears may have slipped,have to pull the door panel to see

gear, it is very possible it is just low on transmission fluid. To check the fluid level, the truck must be running and up to normal temp. That's when you should check the dipstick. If you have plenty

...gear is out side the main box in the extension housing any noise will be from failing bearings I suspect that the clutch shaft bearing and the spigot bearing will be the main problem with metal ...