...metal trigger may rock a bit as the gear turns around. And in your case, continues. Disconnect power if you had it on, and look at the little grey trigger. There is a tiny spring on it and it pivots ...
Question about EASYSHARE CD33 & Printer Dock Series 3 (Pack) Digital Camera
gear which is much less likely to break. I fixed mine by making a clamp from a metal spacer (made from split tube about 1/8 inch long) and force fitting it over the part of the plastic lever that fits
Question about EASYSHARE CD33 & Printer Dock Series 3 (Pack) Digital Camera
gear which is much less likely to break. I fixed mine by making a clamp from a metal spacer (made from split tube about 1/8 inch long) and force fitting it over the part of the plastic lever that fits
...gear is a silver-grey metal catch or "trigger" and resting on - or near it- will be a (usually) copper coloured thin metal "finger. in normal operation this finger catches on the grey metal trigger ...
Question about 4200 Slide Projector
...metal bosses on the sides of the print head frame are under the plastic lever and sector gear. If this is O.K., check for freedom of gear movement by turning the large gear near the stepper motor in ...
Question about EasyShare Printer Dock Series 3
gear which is much less likely to break. I fixed mine by making a clamp from a metal spacer (made from split tube about 1/8 inch long) and force fitting it over the part of the plastic lever that fits
Question about Carousel 4400 Slide Projector
...metal catch that pivots on the wide worm gear. Carefully so you don't spread it, use some rubbing alcohol on a Q-tip, or a bit of WD 40 or other solvent to clean the pivot point of that metal catch. ...
...gear or an actuator that has fallen out of alignment and is getting stuck at a certain point as the lens comes in/out.There is some disturbacnce of the lens arrangement that is preventing the lens ...
metal cuts into the plastic of the gear track and the lens is stuck! It takes a very gentle - and very strong - hand to get the lens out. Special attention should be taken NOT to damage the metal cage
Question about Carousel 5600 Slide Projector
...? Removed btm case, the spring is attached to shutter door next to case wall. Noticed lots of tiny metal particles on various metal parts. Sounds as if the gears are worn. There are other posts to ...
Usually answered in minutes!
1,024 Questions
996 Questions
1,049 Questions
812 Questions
732 Questions