Questions & Answers for: Kia metal gear

...shift & brake OK. You are most likely hearing metal on metal on the brake pads. The brakes are not attached to the gear shift in any way. Unless those Koreans have done some really wierd

...gear lube won't fix that. I'd suggest you do not wait on a repair or metal debris from failure will migrate through the lube and will cause problems with the entire unit. Wish I could give you better ...

gear as well which would acount for the stalling and the grinding,whitch in turn has not done the gearbox any good at all. the starter could be turning over a lot of broken metal. So get it checked by

...metal gear on the motor and a twisted pair of metal wires acts as the other gear. And one or both have wear spot. Sometimes you can fix one by reversing the regulator rod and put the wear spot where ...

metal cover above it and the exhaust cam gear on the right side is done the same but line up the "E" stamped in the gear at 12 o'clock with the notch above it. Make sure they stay in position when the

...gear it makes metal to metal sound. A mechanic replaced 3 pcs. synchronizers but when i used the car, i can no longer **** the gear fro 3rd to 2nd. The car is an old one probably 1997 model, box ...

gear box noise making a slight noise like somethin catching all gears ingaged fine maybe drain the oil and filter and replace with new. If it has a cooling radiator at the front, make sure thats not ...

...isolate the exhaust from all other components using rubber hangers. There can be NO contact with metal on metal, or you will get vibrations. Let me know if further assistance is

...gear should be installed. 6. WRIST PIN SLAP: This can not be detected by shorting out the cylinder plugs. Rapidly accelerate and decelerate the engine speed. The engine will pass through a certain ...

...gear oil in the tranny metal on metal ruins stuff real fast .usually 80 or 90 weight gear oil I personally run 80-90 gear oil but some manufacturers recommend 30 grade for their boxes ( straight ...