Questions & Answers for: what is medium voltage

medium and low. Any suggestions ??? Check the voltage to the switch when turned to high and the power button pushed on. If you are not getting any power there then the setting switch is bad replace it

...voltage from the electrical cord or wall plug, #1 low speed usually a red wire from motor, #2 medium speed usually a blue wire from the motor and #3 high speed usually a black wire from the motor. ...

...medium will not hi, this problem happens when the bower motor resistor goes bad. the reason it works on hi is because it is supplying full voltage and the other speeds are reduced voltages from the ...

...from the blower motor, and check for voltage. Low should be 3 volts DC, low medium is 6 VDC, High medium is 9 VDC, and high is 12 VDC. If you have no voltage, and the fuse is good, you need a

...voltage at the blower motor resistor connector (Key on, relay disconnected), the DARK BLUE/GREY wire should be hot when the control switch is on HIGH.  The DARK BLUE/VIOLET wire should be hot ...

medium 1 blower motor control circuit. Voltage is divided between 3 series resistors, a blower relay, and the blower motor to achieve the desired blower speed. The blower motor is grounded through the

...voltage regulator should i take it off Was it a medium sized wire? If so yes put it back on the battery because this is the charging wire for the battery. The low beams may be simple, they may have ...

medium (blue wire), and high (black wire)... Be aware that these are high voltage wires coming from the blower motor, NOT low voltage thermostat wire.... The typical blower control board has one place

medium 1 blower motor control circuit. Voltage is divided between 3 series resistors, a blower relay, and the blower motor to achieve the desired blower speed. The blower motor is grounded through the

...medium. I checked all the power connections and the voltage is reading a steady 13.9 v. Sure sounds like a "low volts" reboot due to high current draw. Are you measuring voltage at the radio itself, ...