89 MAZDA RX7 I START THE CAR AN IT REVS UP TO 2000 -3000 RPM BUT IT STAY THERE AN IT SMELLS LIKE IT GET TO MUCH GAS AN WHEN I TRY TO REV IT UP HARD IT START TO POP AND IT WANT TO TURN OFF AND IF I REV
...89 Mazda RX7 I was driving it and it started to bog down and was struggling to run I have replaced all fuel lines and filter and even the oxygen sensor and don't know what else to do it still doesn't ...
...rx-7 gtu my 89-rx-7 will start up o.k! and after it get's good and hot! after letting it run for a half hour before i take it out! then when i go to drive it, it start's back fireing real bad and ...
89 Mazda RX7 water on spark plugs and oil and then overheats my 89 mazda rx7 has water on spark plugs and oil. I think is a gasket but I see no sign of leak not sure if is internal. would like to know
...mazda rx7 The starter is mounted on the driver's side bottom of the engine. Disconnect the negative battery cable. Raise the vehicle and support it safely with jackstands. Starter mounting-1986-89 ...
...RX-7 may be equipped with as many as three or four separate drive belts. The belts are arranged at the front of the engine and drive the cooling fan/water pump, alternator, power steering pump, ...
starting problems my 89 rx7 13b is not starting. it cranks over at normal speed but will not start. a couple weeks ago i noticed the 15a(engine)fuse had burnt out. i replaced it and nothing had ...
Question about 1989 RX-7
...Mazda rx-7 that keeps breaking drive belts. I made sure to have the tensions checked but the belts keep breaking. All of the pulleys seems to rotate freely and I do not see any obvious Any help would ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions