...mazda 626 2.2L, replaced headgasket have spark,compression,fuel,rechecked timming marks,#1 cyl up on mark crank on mark tdc, compression 120psi across all cyl.Eng turns over no problem, but still no ...
...mazda 626 won't start 1999 mazda 626 4 cyl was driving and when going into higher gear the rpm's would jump high and not go into gear then later that day car just died down and would not go up a hill ...
...mazda 626 6cyl no fuel geting to onjectors 1999 mazda 626 6cyl no fuel geting to injectors Priority Action Part Type ...
mazda mx6 will not start, turn over on the starter OK, fuel pressure at the injector rails ,ignition spark OK, but injectors not operating Can you help Thanks Ray Maybe the crank sensor isn't working.
98 mazda 626 dx 2.0 #4 misfire. changed coil spark plugs and injector, switched #4 and #3 wires an still getting #4 misfire. any ideas? Try changing the ignition Moduel.Good Luck.
Can I use an engine from a 2000 Mazda 626 to replace a 1999 Mazda 626 vehicle? yes, you will have to change the manifolds and all the sensors and fuel injectors, but the basic engine is the same.
...mazda 626 that does not want to start. If I step on the gas pedal the car then starts and runs fine. what could be causing the car to not start? possibly dirty injectors clean with feul injector ...
...mazda 626 2001 motor turns over bt dosnt start the coil is good and so r the plugs and wires motor wont turn over with key either have to acr the starter Make sure you have a spark at the plugs. Also ...
find code po303 for 2001 mazda 626 2.0 litre Code 303 is for a cylinder miss on number 3 cylinder. It could be caused by a problem with the ignition, fuel injector, or mechanical issue with the engine
Mazda 626 Car is skipping and jumping. Only has 40000 miles Sixteen year old car with only 40K miles must not be driven often, or sat for some time. I would suspect fuel system issue, such as bad pump
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions