Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
washer is skipping through the cycle. I replaced the timer, not the problem. When the washer fills to a "normal level" ,it continues to spurt water. At the end of the first cycle, it drains.Then skips
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
Maytag SAV205DAWW goes through the wash cycle but at the rinse cycle does not drain and spin. It just continues to agitate through until the end. If either the lid is opened or knob pushed and pulled,
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...washer will begin to aggitate then stops after a few seconds. Then at the end of the cycle on the dial, it will spin and drain the wash water out, completely skipping the wash and rinse cycle. It ...
My Maytag SAV5710 washes but skips the spin and rinse cycles. timer bad
Question about Atlantis MAV9750A Top Load Washer
washer will not drain. I have to giggle and push in and out the switch to finally get it to drain. if I just let it run through the cycle it skips the drain and rinses in the same water and still does
...washer works on the rinse cycle your problem may not be that severe. First check to make sure your lid switch is working. The lid switch is a safety device that ensures that the lid is closed before ...
...Maytag Bravos washer, word for word as the original poster put it. I was very disappointed after reading response #1!!! There is a big difference between a OL code and a UL code and the issue here is ...
Question about Bravos MVWB700V Top Load Washer
Maytag Bravos quiet series 300 and it is showing an error code F 81. What is this and how do I fix it the washer cycles down to 40 minutes and skips the wash and rinse cycles and goes straight to spin
Question about Bravos MVWB700V Top Load Washer
...maytag washer when i start it it fills then the cycle starts the timer will count down til it get to 13 min then jumps down to 3 min then shuts off it skips the wash cycle and the rinse cycle befor ...
Question about Bravos MVWB700V Top Load Washer
Maytag bravos quiet series 300 washer fills and drains. Skips the wash and rinse cycles Probably a control board issue. Make sure drain hose isn’t too far into drain pipe creating a siphon effect.
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions