Questions & Answers for: maytag atlantis dryer pull start

...dryer (maytag mde6657byw ).After setting the time with control dial, we pull the control cap out, which should start the dryer but it doesnt, after that we try to adjust the control cap upwards until ...

...Maytag dryer had been getting tempermental and getting harder and harder to get it to start when pulling the knob, now when you pull the knob I get nothing. replace the timer it has a bad contact in ...

...dryer has power but the start cycle knob only buzzes The door is closed tight and the vents are clean. IF THIS MODEL USES THE TIMER TO START THE MACHINE BY PULLING OUT ON THE KNOB, I HAVE HAD TO ...

maytag atlantis dryer mde7400ayw won't run changed both thermal fuses still nothing. the light inside works when pressing the switch on and off. when i pull the start knob the damp light comes on. i'm

...dryer Maytag MDE7400AYW and it won't start. Hi, we have to almost pull the dryer knob off to get it to start. I looked at the parts diagram but not sure what is the part I should be ordering. can you ...

...Maytag Atlantis dryer - when I pull the knob to start the dryer, it won't start. I have found that moving the knob to the left seems to make it help make a 'contact' and start the dryer, but the ...

Maytag Atlantis Dryer pull-knob won't start dryer I think the knob electrical connection has gone bad.. sometimes it works after about 20 attempts. Anyone know an online source to replace the faulty ...

...to pull the stem. Don't pull any harder than you would with the knob. If it works, you just need a knob. If it still won't engage, you need a timer. when pulling out the knob dryer does not turn ...

...pull the knob out to start it doesn't start There is a door switch that not only turns on the light in the dryer, but also completes the circuit so the machine can start. Check the switch by pushing ...

...Maytag Atlantis MDE7400AYW does not start when I pull the knob and I cleaned the sensor and connection and pulled the panel and checked the connection on the board the damp indicator light comes on ...