Questions & Answers for: MSI master boot

...BOOT UP HARD DRIVE ON START UP WINDOWS WILL NOT RUN AND CAN HEAR A CLIKING SOUND COMING FROM THE HARD DRIVE. PUT HARD DRIVE ON ANOTHER COMPUTER AND IT BOOTS UP FINE Is it a PATA (big connector) or ...

...boot screen....i have tried it on my other pc and it works just fine,BUT ON THIS PC NOT EVEN THE LITTLE RED LIGHT FLICKERS TO SHOW ITS WORKING.ITS THE ONLY HDD IN THE PC.....SHOULD I MAKE MY DVD ROM ...

...it or the MBR :Master Boot Record" is corrupt. Try downloading "Hirens Boot CD" and burn to cd and boot from it. It has a lot of useful Utilities on it for restoring MBR and formatting and ...

...Master.Third boot device [ATA IDE drive]If your boot drive is the SATA drive than set: third boot device to the SATA drive. (Hard disk drive with operating system loaded on it). Save your ...

I got k7d ver 1 mb and its not booting when i use two cpu. its switch on and imediately cut the power then i cant boot until i take the power lid for 30 sec. I have tested only primary cpu slot ...

master disk the computer unable to boot and also not detected in the BIOS . It also not boot even I connected it to the cable of the slave disk by removing the slave disk as the slave disk boot in the

...boot priorities but no HDD is shown.. Can any one help me solve this? thanks Hi Good day!! well i think your board didn't detect your HDD for some reason: 1. unexpected shutdown 2. cable not properly ...

...boot. Beep error code is 2-2-3. Problem? Motherboard is micro star MS-9121 in an ibm intellistation Hello the download site is ...

...boot device to IDE-1 means Pri slave escape then press f10 to save to cmos to restart IDE-0 means Pri master ? IDE-1 means Pri slave ? IDE-2 means Sec master ? IDE-3 means Sec slave ? Hope this ...

...boot device:Cd/dvd and second the harddriveThe hard drive must be set as master (by the jumper)The cd/dvd drive must be set as slave.Check also the ide cable for fault.Does the bios see the drive ...