...Makita Model BO5010KX. I replaced the gripe pad and now can't seen to get it back on . Lost my manual. How do I screw the 3 screws back on . I'm at a lost. Thanks for the help. ...
Question about 5" Random Orbit Sander
makita random orbit 5". The pad flew apart. Is it replaceable ? I don't see a bolt or screw holding it on. Usually there are 3 screws holding the plate to the eccentric assembly. The pad is formed to ...
...Makita BO 5010 5' random orbital sander twice since I purchased the tool. The problem is is that the sanding disk does not stay attached to the pad. My most recent pad has only lasted a couple of ...
...orbit! I use orbital sanders in my work daily .Ihave a craftsman and a Makita 6 inch orbital sander.When I replaced the pads, [on both of them] when I started them up, they didnt sound the same ,and ...
...I have had to replace the "pad" and now when I start the sander the screws (3) that hold the pad on tighten to the point the sander will not rotate. Any ideas? Use some loctite thread locker on
Question about BO5010K Random Orbit Sander, 2 Amp, 12,000 Rpm, 5" Disc Size
.... If you want to know about the Makita Orbit Sanders Review go to the link. I think it helps you. Best Disc Sanders For Sanding In ...
Makita part number 211236-8 or a bearing #6002LL. It's fairly easy to replace; remove the screw in the center of the pad and remove it. Depending on which is tighter, the bearing will either be in the
...Makita random orbit sander model BO5010 for years without problems until I replaced the pad with a Porter Cable 13910, sold as compatible. Now the sander takes off, ie: increases speed with reduced ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions