how to change tranny pan gasaket and filter 82 diesel chevy suburban 6.2l Remove All Bolts at Rear of Pan With LARGE DRAIN PAN Under to catch old Trans FLUID. Then Loosen Equally The Remaining bolts ...
...mains, oil pump & oil pan for 6.0 vortec engine thanks Connecting Rods: First pass 15 lb ft. If you have an early first design final pass 60 degrees. Second design 75 degrees. Main Crank Bolts: ...
where is the drain plug for transmission fluid Sorry there is no drain plug for an automatic transmission. If you have a standard there is a plug on the side, you can use a medium sized rachet wrench ...
is it possible to replace the intermediate oil pump drive shaft on a 454 chevy from the top? no you have to pull the oil pan off it installs from the bottom
i need to know were the starter is on a 1988 chevy c 2500 Crawl under the truck and look beside the oil pan just in front of the transmission bell housing. The starter is 4"-6" or so in diameter and ...
I need to know where the knock sensor is on a 1996 Chevy 2500 pickup. knock sensor is in the engine block right side close to oil pan. round looking sensor bolts on.
05 duramax. left outside without antifrize and froze.still runs but builds pressure in radiator reservoir and has water in oil pan. Sounds like a possible cracked head.....I would have it checked by a
4l80e trans won't go in reverse Check your linkage at the column and on the transmission to make sure nothing is messed up there. Check your fluid to make sure it is at the proper level and to see if ...
19974x4GM . can oil pan be removed without pullihg the engine? you can pull the oil pan with out pulling out engine
i need to know what transmission is in my 1994 chevy c2500 pick up 2wd and 5.7 motor i just bought the truck and the ****** is trashed You need to look for the Electronic control module plug on the ...
Usually answered in minutes!
82 Questions
54 Questions
42 Questions
37 Questions
36 Questions