...main control board ? Defective I/O control board 1. Make sure the following are connected properly: ? CN212 and CN229 on the I/O control board ? CN303 on the main control board ? CN7 on the AC drive ...
...main control boards but still no pic so I was told to look for main video board if someone has good video board or if you need main control board I could exchange or sell you main control board for ...
main control board ? Worn Transfer Belt Troubleshooting Procedure: 1. Make sure the high voltage cable and trigger lines are properly connected to the high voltage supply board, I/O control board, and
...Main Control Board timed out before receiving status of drain valve. Check wiring between Main Control Board and drain valve. If correct, replace drain valve. If error still exist, replace Main ...
...Main Control Board If the microwave buttons don't work the main control board is most likely defective and will need to be replaced. Main Control Board If the microwave buttons don't work the ...
Question about 134743500 Fridgidaire Washer Motor Control Board
...the Main Control Board and the Speed Control Board. Wiring bad, correct wiring problem. Wiring good, replace the Main Control Board. If the problem is not corrected, replace the Speed Control
Question about 134743500 Fridgidaire Washer Motor Control Board
...main control board and optics control board) Definition: [level: D] The main control board does not communicate with the optics control board. Possible causes: · Main control board defective · Optics ...
Question about 57029 Side by Side Refrigerator
...main control board failure. The main control board for this model is no longer produced. But, don't scrap your refrigerator because new control boards are no longer available -- Save your appliance ...
Question about 57029 Side by Side Refrigerator
...main control board module - and display control module. WHAT TO FIX/CHECK/REPLACE: Remove power to the refrigerator and reconnect any loose or non-secure connections on the wire harness for the main ...
...main control board - however there is a red light that will flash, replaced thermol fuse, main control board, control board behind the start button- (2) - replaced - hi limit behind the thermol fuse. ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions