Question about 53UDX10B 53" Rear Projection Television
...MAGIC FOCUS BUT I GET A #4 AT THE END OF THE FOCUS. ONCE THE TV WARMS UP THE MAGIC FOCUS FINALLY WORKS AND THE TV LOOKS OK BUT WHEN I TURN IT ON IT HAS THE BLUE SHADOW UNTIL IT FINALLY WARMS UP it ...
Question about 53UDX10B 53" Rear Projection Television
...ultravision the sync on the red is off, magic focus pauses on the red then 4 looks like 3d vision looks like you have an issue with the IC convergence modules. I'd recommend calling in a service
...Magic focus? i have a Hitachi 47'' widescreen 2004 ultravision digital.i have been looking forever and the only way yo fix my Double image problem is to find that.Plus the problem is There are two ...
Question about 53UDX10B 53" Rear Projection Television
...Magic Focus'' doesn't fix ghosting problem I have the Hitachi Ultravision Digital (monitor) and it is giving me the ''ghost'' problem I have seen others have. I attempted to correct it w/the ''magic ...
Question about 43UWX10B 43" Rear Projection Television
magic focus will stop if there is a bad sensor and or a problem in the convergence circuit. This set uses two STK-392-110 convergence chips--both along with any of the resistors that protect them need
Question about 53UDX10B 53" Rear Projection Television
...for any advise. your convergances amps ics have failed and need to be replaced alone with the 2 burnt resistors you will find then run magic focus I have 43UWX10B. How do I get to manal magic
Question about 51UWX20B 51" Rear Projection Television
...the magic focus maybe because the color is only blue and red and the images are zigzag like. Can I fi this without the original remote? no, you need remplace 2 parties- stk-392-110,,,, 7 bucks
Picture looks funny and the magic focus is not working Model indicated cannot have magic focus--it uses a lamp---Confirm actual model number and let me help you. I am here to help. REGARDS, SD TECH
Question about UltraVision CineForm 55VG825 55" HDTV
...magic focus ultravision television, looks like we're looking at 3-D without the glasses The two convergence chips and or a resistor near them will likely need to be changed.Can be a do it ...
Question about 60SDX88B 60" Rear Projection Television
...magic focus has no impact. any ideas? unplugging it. magic focus three times. Pretty common failure with rear projection CRT sets. Sounds like one of your convergence amp chips have gone out. You can ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions
