Questions & Answers for: Dodge lube job

...on the label. Is this teh amount needed for the compressor only. First off is your compressor pre-lubed? to find out, remove shipping caps from ports and tip to side and see if any oil comes out.

lube job and the rest just to get familiar with the car and see anything outstanding. A gentlemen by the name of Russ Knize has a GREAT site with a through talk through and loads of resources for your

...job is messy and you can only get SOME of the fluid changed. I really like the T-tech flush, from lube shops. This changes fluid by installing new until clean comes out, it gets the radiator, torque ...

job .Do I have to take off the whole timing belt assembly ? can I without a Puller? You don't need to remove the cam to replace the seals. Remove the timing belt, making sure to line up all the timing

...broken, if this is the case. simply cut off broken parts and use a piece of 5/8 heater hose to splice it back together. (kneed the hose a bit and use a little light lube to ease the job n your

...job wasn't done correctly,that is obviousMost places don't remove any rust so parts slideas they should ,nor do they lube anythingI have worked on brakes for 50 years come july & neverhad ...

...lube a thing on brakes,I would do that Take them apart again Recheck all work that was done I would drag the brake while on the gas, when it vibrates, to turn off the trans torque converter clutch ...

...lube centers, and parts stores sell and swear up and down are the same thing, guaranteed, to do the same job, for some reason, just don't. People have done all that, and when we flushed out the oil ...

job is VERY IMPORTANT! use a flat screwdriver and pry 360 degrees all around the rubber filler neck hoses. (they get kinda glued on from being on there so long). Next Get some PB Blaster lube or WD-40

the car has a squeaking noise at the front wheels perform a front end lube job, if the problem persists, have the ball joints and/or rack and pinion or tie rod ends checked.