Questions & Answers for: Rheem lowering

test procedure for elements and thermostat Remove upper and lower access panels in upper access, use voltage tester to test voltage of on the uppermost terminals above the red reset button. should be

installed new upper & lower elements & thermostats, only top htr works If original problem was caused by sediment burning out lower element, did you clean sediment out of water heater when ...

hot water runs out after one shower You say the hot water runs out after one shower. You posted under electric heater. In case you have a gas heater: With gas heater, the flame quality could be bad ...

replaced both upper and lower heating elements and while have power in upper there is no power to lower element. Water has heated up but only for short periods and then only cold water. Could this ...

What is the energy factor for the mod.82V80-2? I have two seperate 30amp circuits, one for the top element and one for the bottom element, if that changes anything. ...

replaced both lower and top elements and upper thermostat still no hot water. proper elec. going to unit.what could it be? You need to take 1/2 hour to learn basics and then test water heater parts ...

Not getting enough hot water You posted under Rheem 40 gallon tank-type electric water heater. You have some hot water so that says specific things: -Upper element is working. -Electricity to water ...

replaced both elements and tstats now there is 240 at both elements at once and only the top one is heating the bottom is coldreplaced bottom sgain thinking maybe bad from factory but still cold will ...

I have a 50-gal Rheem tank with two themostats. Are both to operate at same time? I replaced both elements and upper element very coated but lower clean as if not operated very much. If not to operate

got 5 minutes of hot water then cold. replaced both elements and thermos. still 5 minutes of hot water. power bill increased nearly 400% in 30 days. HELP!!! please. When the top of the tank is hot the