Questions & Answers for: low voltage light comes jl

low voltage light hello all i got a jl audio 1000/1 aMp runnin a kicker l5 sub. i have it all wired with tsunami zero gauge wire and 150 amp fuse for some reason when i turn it on it plays for about 3

low ohms light ! ! ! ! it plays music for like 25 not even 10 sec barely turned up and the low ohm light comes on im runing a 1000/1 jl audio amp , 2 w6v2 and a 1.2 farad cap and 4ga. wire slot ported

...connection or low battery voltage.You need to measure the DC voltage across the B+ and ground terminals of the amp to confirm that they're at or above 12v. Let me know if you have any other

THE RCA IMPUT BUT ALSO CHECK YOUR RCA CABLES AND THE SUB INPUT ON YOUR HEADUNIT my 1000/1 jl audio amp is turning on but it gives me the low ohms light and i dont have no subs connected what can it be

low voltage -keeps shutting off at high volume alright i just install a jl 1000/1 and a jl 300/4, 300/4 running all the jl audio xr components and 1000/1 running 1 10" mtx 9500 i ran a 4 gauge wire to

low voltage light on i have a 2 jl audio 1000/1 amps each 1 powers an 12w7. 1 of them sounds great, when they both were on it was unbelievable. the only problem is now i have a blue light on 1 of the ...

When i connect power to it, the power light comes on for about 30 seconds then shuts off. I've never experienced such a thing... I've had similar problems, usually for me it ends up being a bad ground

...low voltage light would indicate that there is not enough power reaching the amplifier through the power wire. Are you using 4awg or bigger wire? Is the amp grounded well? Does this happen all the ...

...low. What can I do to fix this? please help Do you have a capacitor????? If not, when its up loud and hitting hard it might be going into protection because of a voltage sag....If it goes below 11.8v ...

...low bass comes on it drops the voltage on my truck and breaks my circuit breaker(300amp). I have a yellow top optima battery under the hood with 0 gauge wire to the amp. Any suggestions on how to fix ...