Question about Eltron P520 High Speed Printer/Laminator (P/N P520C-E000U-ADO)
error message i have eltron card printer when i power on the printer there is massage Mechanical Error Ready on the printer display what i will do pls. answer me urgent thank Issue related stuck due ...
Printer is printing off center I have a n LP 2824 printer. everytime I print, the print is off center causing my bar code to be unreadable (too far to the right). Currently I have to use a spacer to ...
prints only part of label the printer stops feeding the paper before the end of the label and the gree light goes red. remove power and will turn on green light and will print the nex label in part ...
no mark its just plain old paper and wont work. you will need thermal direct paper. also in printing defaults in the driver the darkness may be too low and need to be raised, but check the paper first
Question about Eltron TLP 2742 Thermal Label Printer
zebra tlp 2742 with 1"x1" (two across) labels setup problem. Trying to use labels that are 1"x1" and two across in a zebra tlp 2742. Having difficulties, used to work, but recently moved and are ...
Question about Eltron LP 2824 Thermal Printer
using a eltron tlp2742. The printer spits out about twenty lables then prints one halway in the middle of a tag then stops. I have chaecked all paper, ribbon, connections and settings on printer I can
Question about Eltron LP 2824 Thermal Printer
...speaking the alignment is done in the software program. Look thru the program for where it allows you to aglin the
I wanted to know what type of ribbon does Eltron TLP 2742 take and what is product number and how much are they? The quality depends on the type of support you are using It can be wax / waxResin or ...
Question about Eltron LP 2543 Thermal Label Printer
My eltron ip2844 wont print dark enough. I went into setting and turned the burn darkness to 15, but still not dark? Help!! This may be due to your thermal paper. This printer doesn't deliver ...
2844 paper sticks out You need to set the reverse option on the driver, to reverse at end of label. Hope this helps
Usually answered in minutes!
80 Questions
47 Questions
55 Questions
34 Questions
32 Questions