Question about 18-inch Electric Chainsaw Chain Saws
...chain does expand as it heats up so it may loose tension... so this is perhaps best done when the saw and chain has warmed a little. Also, new chain will stretch a little naturally so check tension ...
Question about Factory Reconditioned 10-Inch 18 Volt One+ Cordless Electric Chain Sa
...Chain is loose. Where do I tighten it? Thanks Ros loosen the two nuts that hold the chain cover on. Once they are just loose, then use a flat blade screw driver to turn the slot that you see right ...
Question about 18-inch Electric Chainsaw Chain Saws
...with clutch springs and shoes, i think you have been running the chain a bit too loose or not running it at realy high revs ,which is what they are designed to do ,cme back to me if you feel the ...
Question about 18-inch Electric Chainsaw Chain Saws
...chain is obviously loose. Using one hand, hold the nose of the bar up. While holding the nose up, adjust the tensioner so that the center of the chain just touches the underside of the bar, add a ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...chain is obviously loose.Using one hand, hold the nose of the bar up.While holding the nose up, adjust the tensioner so that the center of the chain just touches the underside of the bar, add a touch ...
Question about Factory Reconditioned 18" 40cc 2-Cycle Gas Powered Chain Saw #ZRRY10532
...loose enough to allow chain to come off. If you have it to tight it puts added strain on both the bar and chain.Also always make sure you have chain oiler set to keep a film of oil on chain at all ...
Question about RCS3535CA 14-inch 35cc Petrol Chainsaw
...Loose the blade tension. -Remove the old chain then put new one in. Tight the tension to to good or until the chain still turn smooth. (Not over tight) Tight the locking nut. -Put the cover ...
...up on chain it will raise the teeth that go in the bar groove to about half way. Do not over tighten or will burn up the bar, better a little loose than to tight. Don't forget to re-tighten bar
Question about RCS3535CA 14-inch 35cc Petrol Chainsaw
...chain is also too loose. I have adjusted the tension mechanism to the max but the chain is still too loose. The chainsaw worked well for 2 or 3 years until this problem occurred. Adjust the chain bar ...
Question about RCS3535CA 14-inch 35cc Petrol Chainsaw
...reduce chain tension and leave cover loose. If still won't move, loosen cover more or remove cover.
Check the chain is correct pitch and drive links mate properly with the drive
Usually answered in minutes!
295 Questions
300 Questions
122 Questions
96 Questions
40 Questions
