Error Code showing UC Maytag Neptune showing an error code of UC Hello plthrsn64 , You should open up a separate problem for this but I will post as a solution for the Lid Lock Issue. For the ...
Fails to lock Back story: Changed to clutch and everything worked fine. Thanks for all who offered advise. Left the front panel off for about 6 loads just to be sure everything was OK. No problem. ...
Question about Neptune FAV6800AW Top Load Washer
...lid lock position. I don't mind replacing the locking switch if I knew it was the problem. I don't want to throw $60 at a piece of junk and not have it work. I'd rather buy new & cut my ...
i get sevice code 234, what does it mean 234.(11101010) Phase 6 - Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and lid lock ends. Primary Fault: ...
fisher and paykel gwl15 has a code 234? cant find any infoon this code Fault code 234 234. (11101010) Lid Lock Open Circuit Check Harness to Lid Lock and connections at the Motor Control Module and ...
aquasmart lid lid wont lock Is the lid lock tang on lid broken. 2.9 Lid Lock The Phase 7 Washer uses the same lid lock that is used on the Phase 6 series 11 & 12 machines. The difference being is ...
Question about NTW4700YQ Top Load Washer NTW4700YQ
amana washer lid lock wont quit blinking washer was not in use and lid was up. lid lock light started blinking and now washer will only fill and drain-will not wash or spin Your washer lid lock button
why does my lid lock keep flashing? changed lid lock but having the same problem. There is a right lid lock and a left lid lock which did you change? The left lid lock is a lock and the reed switch ...
Question about Neptune FAV6800AW Top Load Washer
...lid locking led is blinking after lock the lid and stay standby with out working ? power off by unplug and wait few minutes and again tried but the result is same The unit will not operate in this ...
Question about Aquasmart wl80t65c
WL80T65CW1. Why is it displaying fault 234 and will not cycle? I OPENED THE LID LOCK & IT LOOKED A SALTY CORROSIVE TEXTURE ON EACH END OF CONNECTION. ALSO THE TOP LID GROOVE THAT SLOTS INTO THE LID ...
Usually answered in minutes!
9,060 Questions
3,702 Questions
3,155 Questions
2,982 Questions
2,656 Questions