Little metal clamp on my pull string I have a push mower with a weird problem. I was using my mower just fine this afternoon. When I went to restart my mower I noticed this little metal clamp on my ...
...24.. yes 24was this set wrong at the factory?I thought 8-10 was the norm.Spark is yellow with very little bluecan't get it to start.Do I regap the CD & then clean the carberator?If so what
Question about 22" Yard Machine Push Mower
the end of the rope. Short enough that it winds all the way up. When I replace these things I use a little more than an arms length. 3 foot or so. I wind the spring till it is tight then slide a screw
Question about 22" Yard Machine Push Mower
...behind mower. The pull cord will not pull to full extension to start the mower. It will pull out a little and then seems to get stuck. Any assistance would be appreciated. From what you describe it ...
Question about 22" Yard Machine Push Mower
...and using a cigarette lighter singe the end of the rope to seal it. *(most true recoil cords have a little nylon in them that will melt to create the seal) This seal keeps the end from fraying or ...
Question about 22" Yard Machine Push Mower
...assembly. It warps from heat and sucks air. You can remedy it with some masking tape across the little curved passage in the plastic housing on the carb side. Just put the tape on and then cut to ...
Question about 22" Yard Machine Push Mower
...motor and transmission....which could be a worn belt or a weak or broken tensioning pulley.. or a little of both..but if they look good the what it is I would be pretty sure...at the bottom of the ...
...a knot as close to the end of the cord as possible and pull line back towards the outside with a little strength to "seat" the knot. Remove screwdriver and let the tension of the spring rewind the ...
Usually answered in minutes!
700 Questions
213 Questions
216 Questions
140 Questions