Questions & Answers for: GMC my little house

...of that is the thermostat housing. there's two bolts holding it on. remove that and any other little brackets that are in your way and it's right there under that housing. Drain a few gallons ...

...Remove the old thermostat and clean out the area, place the new thermostat and you an use a little RV silicon gasket sealer or you can just place the thermostat in place the tighten up the ...

...It has condensation inside the clear enclosure. If it has no visible cracks, it may just be a little vent on back of housing is plugged. They usually have a small round piece about 1/4"-3/8" on ...

...Sierra - driver side headlight bulb replacement On top of the head light housing there will be two little metal rods about 1/8" round. They wiil be on each side of the housing on the top.Turn these ...

...the clamp on the hose at the eng. Twist the hose from side to side to break it loose.(it may be a little stuck) Slowly remove the hose and let drain. Remove the 2 bolts that hold the thermostat ...

...a thermostat on my 2004 It Depends on which engine you have, this is how it goes for both. I use a little RTV with a new ring as well. THERMOSTAT REPLACEMENT (4.2L ENGINE) Removal Procedure 1.

...hood, they are generally on each end. lift the two pins up, and the housing will pull out with a little wiggling and by pulling the end closest center of the car out first. The bulbs will be easy ...

...see blower housing. unbolt it and you may have to remove one dash bolt at bottom pry dash out a little and remove ...

...thermostat, push in new one and clean off the old gasket on the housing.Reinstall you will lose a little coolant, so be prepared.Hope this helps please let me ...

...all. If its warped too bad I would replace, if its not I would replace seal and thermostat. Use a little RTV silicone around both sides of gasket as well. This should eliminate your leak. Good