...find how to get to it thanks shari follow your top radiator hose to the engine...is should go to a little rounded housing that is held down with a couple of bolts....it is under that ...
...filter is mounted on the rear of intake manifold, under air cleaner or on rear firewall. Just a little hint on replacing it, remove your fuel tank cap to release pressure or vacuum in the tank. ...
...hatch are out to the fender. then pull the housing away. on the back of the housing remove the 4 little bolts that hold the board on. pull board away from housing. pull the bad lamp straight away ...
...Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end ...
...your car is cold, then put a pan underneath vehicle below the thermastat housing,You'll loose a Little Coolant ,So this Way you can catch it. Just Loosen the Rad. Hose Clamp and Pull off the Hose ...
...thermostat came out the new one has to go back in the same way when installing the housing i use a little sealant to help keep it from
...to get off. The top one is another story and you have to get at it with a wrench and turn it a little at a time because you don't have much room to turn it. A little pointer is to do the top ...
...the housing that is bolted to the lower intake manifold that the upper hose is attached to. With a little creativity you can pull this housing without pulling anything else. It does make it a little ...
...take a socket wrench and give the bolts a couple of turns. Not too tight-you can always turn them a little tighter if it starts to leak there after you have filled up the coolant, started the engine ...
...engine. I missed that bulletin current specs, 89 inch lbs or 7.4 ft lbs. Best idea is tight and a little bit more. ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions