dim for 2 or 3 seconds then light ups and begins flashing 9 times and has been doing this repeatly for weeks. the air conditioner works fine. and this is a heating related problem if I'm correct. make
...lights dim and then the comopressor stops) i went up to check the motor and the fan in there is not turnable really. it seems like the AC compressor gets runnin and then i semll kindof a burnt rubber ...
Question about 2000 Elantra
...lights dim, clock dims I replaced the battery last week, the alternator was replaced in January. Power steering belt recently replaced. When vehicle reaches what appears to be normal operating ...
Question about (PSS26MSRSS) Side by Side Refrigerator
...lights dimmed with each click. When I pressed the temp control panel it flashed. I played around with all controls and everything started working again. Problems seem to be coming more frequently and ...
...lights go dim. any ideas number one you need to have someone run a check for diagnostic codes using a scan tool. two sounds like you could have a weak alternator when the cooling fans cycle on it ...
...blown or burnt. It lights up but the light is dim. Can this be fixed? maybe that's the cooling fan ur hearing if not make sure connections and tighten monitor the sound could be something goin ...
...lights dim and there is a humming noise for just a few seconds before the hum stops. The fan runs and will blow "cool" air but not as cool as it should be. What is my problem here? I dont ...
...cooling and draw too much amperage and cuase the light to be dim. My suggestion before trying to diag is go to www.aplliancepartspros.com and look up your fridge by model number and locate the ...
...cooling fan will come on at 215 and run for about 1 minute and shut off...any Ideas? Also My lowbeam works(2 new bulbs)but when I swith on the high beams light goes off completely. Switch is good. I ...
Question about 2001 GSX-R 1000
...lights to dim. Pull the unit away from the wall and unplug it, remove the lower rear cover, should be around eight 1/4 inchs screws holding it in place, If you have a screw gun with a bit holder the ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions