Starting. Turns over but won't fire Hi My fat boy turns over two or three time and then starts clicking like it is not getting power or the selinoid (sp) is not working. Battery? Starter? Suggestions ...
my rear brake light will not go on when i use the foot brake i have a 1999 fat boy Your rear brake pressure switch is bad. Find the rear master cylinder under the right footboard of your bike. There's
just had a screamin eagle race tuner installed and dyno driving bike at 40mph down road and then it shuts off , can fire back up but have to keep giving it throttle, then all the sudden its fine, ...
Question about 2003 FLSTF Fat boy
2000 fatboy will start but wont stay running, have replaced the map sensor, crank sensor, cam sensor. Put a new ignition module and a new coil. Sounds great when it starts but wont stay running. Have ...
Question about 2000 FLSTF Fat boy
starter will not turn over not even when jumping just clicks any ideas 2000 fatboy Joe, the power travel from the batterie to the relay switch, from there to the ignition key from the ignition ...
Question about 2003 FLSTF Fat boy
2003 fatboy starts runs for about 3 seconds and quits. Alarm is off, fuel is good, batteries replaced in key fobs. Whats wrong? When ignition is turned on you can hear the fuel pump running. I checked
...lightning equipment or luggage tends to cause unstable handling. 2. Incorrect air suspension pressure. 3. Damaged tire(s) or improper front-rear tire combination 4. Irregular or peaked front tire ...
why wont my brake lights not work my brakes lights are not working on my 1993 Harley fatboy neither with front brake lever or back brake pedal Check the wiring underneath the rear fender for damage ...
why wont the brake lights not work on my 1993 fatboy brake lights not working neither front or back what and how can I check? Check the wiring under the rear fender for damage. Check the bulb by ...
need a wiring schematic for a 93 fatboy Harley davidson need to know if the coil wire from the ignition is 12 volt. put a multimeter on the coil wire , set the meter to 12 volts dc and turn on the ...
Usually answered in minutes!
194 Questions
152 Questions
134 Questions
13 Questions
12 Questions