Questions & Answers for: Chevrolet Uplander lift gate stuck

Squeaking near belt area There is constant squeaking near the belt pulley area have you tryed replacing the belt when and if you replace the belt check the pulleys that are driven by that belt for ...

the way to change out the rear wiper motor? You have to remove the large plastic trim panel at the inside of the rear door/gate to get at the motor. The panel is held on with a series of push-in clips

I need to know how to get the spare tire from under the Uplander. I am second owner and have no manual for my van. Please help me. Do you have the original jack and related tools I hope? The jack is ...

...lift gate panel out at the window so I could look down and see the lock mechanism at the bottom of the lift gate. I reached down and prodded it with my screwdriver until I noticed that parts of the ...

...LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE PUTSIDE OF THE LIFT GATE, THEN THE BEZEL, DONT SCRATCH PAINT ON THE LIFT GATE, REMOVE THE UPPER AND LOWER LIFTGATE INTERIOR TRIM PANELS, ...

...lift gate for the Chevy Uplander has some plastic and rubber-coated parts that can get jammed. If you can pull back the panel from the inside top near the glass, you can reach down and try to spray ...

keyless entery only opens drivers door the key less entry and drivers side lock switch only opens the drivers side. When the vehicle is put into drive all doors lock this is normal. When the vehicle ...

...lift gate lock stuck in the closed position The rear lift gate latch is stuck in the locked position when the the door is open.......how do you manually release? use a round bar under the lock tongue ...

lift gate lock/latch stuck in the closed position while the door is open.......how do i manually release or open the latch? use a round bar ( a screw driver ) and place it under the latch and pull the

...Lift the tail gate. There are clips or screws along the top edge. Remove this. The clips all you do is pull the center pin with a panel tool or pliers then the rest will come out. Then you will need ...