Questions & Answers for: Chevrolet Silverado 3500 how see the life time

Question about 2006 Silverado 3500

1 Answer

...on the radio for about 6 seconds and it should go into settings mode. Press DISP until you see oil life in all caps, then use Prev. & Next to scroll to reset oil life mon., then push DISP again. ...

Ad

The instrument cluster doesn't always come on and work. It's intermittent. Any ideas? I would first check (pull and re-plug) any connectors you can spot under the dashboard. This kind of annoyance can

Ad

...life-time, no need to change type. These are located inside the tank itself. Modern day (cars after 2001) use a pump & sender assembly unit. You can normally access these through an inspection ...

2001 durimax 3500 dula fule gague dose not work 2001 durimax 3500 dual weel fule gague dose not work reads empty all the time. sounds like a ground proublem try to reach top of fuel tank an wigle ...

...Life System calculates when to change the engine oil and filter based on vehicle use. Any time the oil is changed, reset the system so it can calculate when the next oil change is required. If a ...

Question about 2001 Silverado 3500

1 Answer

I have the caliper and caliper housing off ready for the rotor to come off but it seems to be seazed on. I have beat on them like you would to normally get a rotor off but it hasnt come off yet. I am ...

havin a problem with our 88 truck back firing from exhaust have changed spark pulgs, spark plug wires, distribitor,rotors,ignishion modulater, fule pump, fule filtter. when we got all that changed ...

Question about 2003 Silverado 3500

1 Answer

reset oil change mileage bring up oil life on the display then press and hold reset.

Question about 2003 Silverado 3500

1 Answer

Ignition Key Will Not Turn You have a bad lock cylinder. This is pretty common on most GM cars. You can try tapping the end of the lock cylinder (where the key goes in) with the hanle end of a large ...

WHY DOES MY ALLISON TRANNY NOT SHIFT RIGHT ALLTHE TIME WE GET A CODE PO700 TRANSMISSION SYS FAILURE. Start the engine & put into reverse, most of the time it will go into reverse for a few feet or not

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...