Questions & Answers for: lid catch Vacuums

Question about F5906-900 Upright Steam Vacuum

1 Answer

on the catch bucket engages without any warer,or when I turn on the machine. The foam filter is up too high, it is on the bottom side of the lid. Leave about a 1/4 in gap, then it should work ok again

Ad

Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum

1 Answer

...catch tank, it was dry. What could be wrong? I thought I went slow. Which you had posted your model number, If you have a foam filter on the inside of tyhe recovery tank lid, make sure there is at ...

Ad

Question about F7431-900 SteamVac Vacuum

3 Answers

...catch on the back. There also may be a foam filter inside of the recovery tank lid. Make sure there is at least a 1/4 in. gap from the top. One other filter is from the bottom, it has a red frame, ...

Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum

1 Answer

lid is secured down all of the way around, sometimes it doesn't catch and will **** up. Also check the filter on th inside of the recovery tank lid, it needs to be at least a 1/4 in. gap from the top.

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

1 Answer

Hoover SteamVac F5905900 The recovery tank lid will not snap in place. The back latch will not hold. Can you tell me if I need to order a new lid or the whole tank. If so, can you give me the part ...

Question about SteamVac F5914-900 SpinScrub Upright Vacuum

1 Answer

...catch that holds the accessories lid down on a nilfisk x300 vacuum cleaner. it also forms part of the handle. Where can i get the part and what is it called Hi there SmartAlec from ...

Question about DC07 Bagless Upright Cyclonic Vacuum

2 Answers

...catch won't release, I cannot remove the entire clear bin either from the cyclone.Any suggestions? Beofre you go to the extent of buying a replacement canister, you can remove the top and using a ...

Question about DC07 Animal Bagless Upright Cyclonic Vacuum

1 Answer

catch which the lid clips into ) however the lid pops off the catch andboth the lid and filter below it ( and held down and in place by it ) comes loose causing no **** and a loud whilstling noise The

Question about DC07 Animal Bagless Upright Cyclonic Vacuum

1 Answer

...catch to release the dirt container is a screw - remove that and then remove the 3 screws on the purple lid with holes in it, remove the lid & clean the "cyclones" - mine were all blocked. Make ...

vacuum cleaner miele tool cover lid needs a new catch to hold it down. Do I have to buy a whole new attachment unit or can I buy justthe bar with catches on. Contact Miele directly with your inquiry.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...