Questions & Answers for: Lexus lid catch

the hood will not pop open the hood will not open when the release is pulled any info would be very beneficial. There is no easy way to get the hood open to repair the problem, here are the common ...

...catch on the trunk lid but do not remove it and the lock mechanism, close the trunk lid but not fully, then pull the backseats down and climb into the trunk. Adjust the lock and latch until they meet ...

...catch on the lid that locks onto the boot floor when you shut the boot. Well if you use a screw driver and push the lock round as though the latch would when you shut the hatch. I mean on the hatch ...

1997 ES300 Trouble Starting I have a 1997 Lexus ES 300. I have trouble starting the car after it has been parked overnight. The car will attempt to start but it won't catch on the first try. I can ...

The trunk release on my 95 es300 in the driver door next to the gas lid release will not work. The gas lid switch works fine but not the trunk. How do i fix it. MAKE SURE THE CABLE IS NOT BROKEN OR ...

How to remove old trunk lid shocks on the LS 430 Replacing the trunk lid shocks At each end of the gas spring lift cylinder there is a spring steel "U" shaped clip, pry it off and the shock comes ...

...the hood Raise the hood of your car and look near the battery for a black, plastic box. Unsnap the lid and raise the cover. On the inside of the lid there should be a schematic of the fuse ...

how do i Adjust trunk lid for 2010 Lexus ES300, driver side corner lifted.. ? The usual method for most cars is to use shims between the lid and the hinge, but not sure if this works for yours.

...ls430 Not, easy! The Bulb comes out from the inside of the Trunk So, you need to remove the Truck lid inside panel (See Video), reach up behind where the light attaches on the trunk lid, twist the ...

I have a 2011 Lexus 570 LX I'm trying to figure out how to remove a console lid it's a dual lid on a cool box to reupholster it. SOME CARS SEATS MUST COME OUT TO REMOVE THE WHOLE CONSOLE TO WORK ...