...lhs 1999 transmission wont shift to 2nd and 3rd gear but drives on low gear foward and back. It sounds like it is in limp mode. This is to protect further damage to transmission. You need to take it ...
Where is the Transmission Control Module Located on a 2001 LHS? I know that it is at the computer but where is the computer? TCM location
...99 lhs won't start either. It just rolls over but donsn't get spark. the starter is on the right side of the motor down below the the air intake bolted to the transmission three bolts and it comes ...
Where is the Crankshaft position sensor located on a 1999 Chrysler LHS 3.5L SFI HO 6cyl Mounted on transmission
...lhs transmision wont shift when hot sounds like a blockage in the transmission lines. try to have it flush to see if it help and if not then you may already have internal damage. please ask any more ...
...transmission in my 2001 lhs no the car turns but will not start'it worked perfect befoer noe there seems to be no fire to power packs make sure you hooked up the crank sensor on the transmission. If ...
...LHS? The crank sensor is located in the transmission bell housing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. One 10 mm bolt holds the ...
...LHS you should be able to see the pan from under the vehicle. it will be the pan closest to the rear, then you need to drain the transmission, unscrew the retaining bolts for the transmission pan and ...
...LHS - Check Engine light came on and I took it to have it checked and the code was the P740 Torque Converter Clutch is slipping. I have had the transmission flushed and the filter changed but the ...
Location of crankshaft sensor on a Chrysler lhs 2000 Passenger side of motor bottom by transmission housing. Hard to get to from top of motor but not impossible.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions