Questions & Answers for: GMC latch want release

Question about 2002 Sierra

1 Answer

there to release the latch handle (as I pulled on the latch handle) and it popped open. I then squirted some WD-40 on that latch mechanism because it was hung up. I didn't have any problems after that

Ad

...(corroded, warn out, needs lubricating, etc.). You will need to remove the rear gate inside panel to see what's wrong and manually release the latch, and then likely replace the latching

Ad

...hood adjustment for the latch is too tight, pull the hood latch, go out to the hood and press down on it at the latch location, push hard and release quickly, then adjust the latch before closing ...

Question about 1995 Suburban

1 Answer

...latch for the hood release inside the car, you can hear the hood pop a little but not enough to grab the latch under the hood. The hood bumpers are worn or misaligned. After pul;ling the vever, push ...

...latch release.Keep pushing the tailgate against the vehicle and keep squeezing the switch until you hear the second latch release and the tailgate should fold down. Is there any good pictures of the ...

Question about 2004 Envoy

1 Answer

...latch to release even when pulled all the way with vigor 3. Rear window wiper stuck in upright position and won't respond to off-on switch Thanks The no heat problem could be a stuck open thermostat, ...

Question about 2000 Sierra

1 Answer

...you to remove it and replace the plastic part that holds the release rod in the latch release. You can buy the clips for $3 at any auto parts store. No need to buy the whole handle thingy ma

Question about 2005 Yukon Denali

1 Answer

...at the rear of the seat where it attaches to the floor you can see the latch and manually release it with a long screw driver or similar tool. Cables are avaiable from GM dealer if thats the

...latch release relay. When the release switch signal is activated, the BCM enables the liftgate latch release relay by applying battery voltage to the liftgate latch release relay supply circuit and ...

latch assembly,now get a screw driver and manually pull/pivot the hood release cable back,now put a new extra spring on the pull cable arm on the latch assembly after you have loosened the latch cable

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...