Questions & Answers for: Chevrolet Silverado lamp module

...Brake Control Module) "ABS module". "Service Brake System" message on dash, ABS and Brake warning lamps lit as well. May be the R/F ABS wheel speed sensor, but what you described happen, shouldn't ...

...module on a 2002 Chevy Silverado. can you tell me where to look Remove the IP trim bezel. Pull out the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly in order to ...

Module (PCM) . The PCM supplies the ignition voltage to the generator lamp feed. This ignition voltage is pulled low by the generator once the ignition switch supplies ignition 1 voltage . The voltage

2005 Silverado - Hazard lamps come on when I use right turn signa When I use my right turn signal the hazard lamps start blinking but they do not come on when I use the left turn signal. Anyone have ...

lamp, circuits to turn them on. However, today the door switch grounds the circuits for the Body Control Module which controls a number of different things as well as starting timing circuits. I think

...the DRL relay in the same fuse/relay box .Your light sensor could also be bad . The daytime running lamps (DRL) will operate when the ignition switch is in the RUN position, for automatic ...

...module (BCM) receives a signal requesting to illuminate the backup lamps, battery voltage is sent directly from the BCM through the backup lamp supply voltage circuit to the backup lamps. Voltage for ...

...module (BCM) provides the ground path for the LED through a dedicated LED control circuit. Pressing the switch again opens the switch and the lamp turns OFF. DTC P0571: Cruise Control Brake Switch ...

...module . Interior Lamps Dimming The second group includes lamps which may be dimmed. This group may use a combination of vacuum fluorescent (VF) illumination and incandescent lamps. When the ignition ...