Question about Fellowes Saturn SL 125 12.5-Inch Laminator
...Laminator will not heat up, neither the green or red light turns on. Motor runs but no heat for laminating. Brand New, barely used, maybe 10 sheets through at most. We have an old Fellowes laminator ...
Question about Fellowes Saturn SL 125 12.5-Inch Laminator
...ink jet printers are known to have the ink melt in the machine. There are other types of printers that use heat sensitive paper. For these types of applications the cold laminator is the best
Question about Laminating Film, 27 in.x500 ft.,
...fix everytime, just follow the wires from each heat shoe (right side of laminator) cover off. Ohm each set of wires and look for an open circuit. replace fuse (TCO) and it will work
...heat up laminator will turn on. Initially ready light is on as well but fades away in about 5 seconds. Heating light never comes on. I tried the run button to see if roller move freely. They do. Do ...
Question about TL902VP Scotch 9" Thermal Laminator Value Pack- With 20 Letter Size
Scotch Thermal Laminator not heating up. I have Scotch Thermal Laminator (TL902). It was jammed last night with the whole laminating sheet rolled onto the rollers. I was able to solve that problem by ...
Question about HeatSeal Ultima 65 Roll Laminator
...Main Board, but haven't located it. If it doesn't have one, what would cause low heat? Ordinarily, laminators have speed controls to allow the laminated substrate to get hotter. Yes, your can adjust ...
Question about HeatSeal Ultima 65 Roll Laminator
...laminator heats up but won't pull the laminating pouch into the machine. Last time I used it it worked fine. Maybe it just doesn't heat up to a needed temp Hello! That's a real problem. To be honest, ...
Question about HeatSeal Ultima 65 Roll Laminator
I have a Scotch Laminator Model # TL1302 which has suddenly stopped heating up. What could cause this to happen? There could be a few possible reasons why your Scotch laminator has stopped heating up.
Question about HeatSeal Ultima 65 Roll Laminator
laminator may not be holding the heat properly: Dirty or damaged rollers: Over time, the rollers can accumulate adhesive or other debris, which can affect their ability to grip the laminating film and
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions