engage clutch there is a slight knocking noise coming from side casing like gears are touching but not completely engaging when i engage 1st gear it clears Drain the tranny oil and check for any metal
...250 will not go into gear. When I change into 1st gear the neutral light goes out but the gear will not engage. try to change 1st gear to the last if all of the gear does not engage you have a high ...
...clutch doesn't engage. First, get a new clutch cable. Tape the new cable to the old one and unhook the old one. Now you have a new cable and a reserve cable ready for use if needed during a race. ...
...Kx 250. everything went smooth, or so we thought. when we finished the installation the clutch would not engage. were thinking that we didn't install the push rod correctly. the push rod goes right ...
i can pull my clutch but it doesnt engage my clutch doesnt engage at all Does it not engage (drive) or disengage (releaase)?
Question about 2004 KX 250 F
kick start has no compression but runs fine once i get it going kx250f '04' model, not much bike knowledge so, the bike has had new pistons, rings, valves, cam, cam shaft, gasket im not sure wat the ...
...kx 250 put a new clutch lever on now clutch cable has 2 much play and wont engage tried adjusting to no avail Be sure you were given the correct cable, The stock cable is part number 54011. Compair ...
clutch not engaging cable feels very slack recently snapped clutch lever off my bike put new one on cable has 2 much play tried adjustin to no avail ok, three different possibilities here. first, you ...
bike wont freewheel when in gear and clutch is engaged and engine not running ? is the clutch broke ? hi, this could be as a result of mall adjustment, or simply clutch plates stuck together as a ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions