The ac is turned on, just blows warm air, then the light starts flashing(on the ac knob) It's charged..any suggestions? Its possible that your car is low on refrigerant. have it refilled.
...to defog the windshield. You hear it blowing, but it is not coming out. I have switched the knob to change the airflow direction from the cabin to the cabin/feet to the feet only to the ...
The air control knob (defrost, floor, face) doesn't work at all. It feels like it may be an electronic knob rather than the old lever type knobs found in older vehicles. Any idea as to where to look ...
knob commonly behind it has a steel cord that moves the mechanism , probably the cord is loose but it can be set in place again manually, maybe you have to disassembly some parts of dashboard to do it
2004 Mitsubishi EndeavorTroubleshooting Code P0442 code p 0442 refers to evaporative emission(EVAP) system---small leak detected ===causes --hose connections--intake leak---EVAP canister---EVAP ...
Question about 2006 Endeavor
Why does my 2006 mitsubishi endeavor limited has problems starting right away? I have to repeatedly turn key 2 to 5 minutes before it starts Hello -- I thought I already replied to this question -- ...
mitsubishi motor turnsover but will not start after installing water pump on 2004 Endeavor 3.8L Did you knock a wire loose? Look at the coil wire to make sure it is connected well at both ends. Look ...
headlight s out rt. low beam first, so replaced both with new bulbs then rt. went out and then the left as well as the fog lights. i assume a fuse It sounds like a fuse, a loose wiring harness, or a ...
like mitsudshi endeavor shake at high speed? If your front end is out of alignment this could happen and or wheels out of balance. A loose motor mount can also cause a vibration
Question about 2011 Endeavor SE
when the car is shut off radio looses memory after several hours. Check constant live to radio!
Usually answered in minutes!
739 Questions
190 Questions
94 Questions
77 Questions
4 Questions
