...inoperative. It shows output level signal regardless of where the knob is turned. Input gain works. It sounds as though the ground connection to the fader control has gone missing. Check with a
...under the faring at the radio. You will have to drill a hole in your panel to install the fader knob. I bought my speakers and fader knob from J.C Whitney and it didn't come with instructions
Question about Xenyx 1002fx Mixer 10 Input 2 Bus with Efx
...the main fader The utput fader has probably been broken. If the knob takes a hit, it breaks the resistance element. The part is inexpensive but it takes a lot of work to access and replace the
...from front to back. The Fader may be a knob or a slide. However it appears on your radio, it should be marked. If it's an aftermarket, press Func until the Fader screen appears. Best regards Mike
...fader knob on after cleanig the number 5 and 6 faders seemed to shift from behind the panel and those chanels are completely out. You may have destroyed the faders. If excessive force is applied to ...
...of CRC226 in the center of the slot of each fader and then move fader knob to top and bottom. CRC226 is available in the electrical department of Home Depot in a small can with spout... about ...
...knob above the MAIN fader that says FX to Main. This controls the amount of the FX that is sent into the MAIN mix buss... We are almost there... Select the effect you want with the effect knob to the ...
Question about Pv 20 USB 20 Channel Mixing Board with USB Input
...fader knob doesn't do nothing. No sound come out from my right speaker when I turn the right knob up right fader knob doesn't do nothing. No sound come out from my right speaker when I ...
knob is at "3 oclock" Raise the MAIN fader to "0". Check LED's - if they light up then the channel you are working on is "noisy" or has a short in it. Return GAIN, LEVEL, and MAIN to "all off". Repeat
...power flat cable and the other flat on the PCB, make a photo to remember the colors of the knobs, then remove the knobs and screws on the top panel (only the plate that also houses the fader ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions