where is the Mass Air Flow Sensor on a kia rio Between the air filter housing and the intake manifold, left side engine compartment.
kia rio 2002. i used the product name as spectra below but it is a rio. Its in your intake by the air filter. Remove the intake tube and there are a couple of bolts holding the sensor in place Its the
Kia Rio almost stalling My Kia Rio Misses on days it is damp and rainy outside when i start it up until it warms up? I changed plugs and wires and it still does this ? also where is the distributor ...
...my 2005 kia rio The intake air temperature sensor (IAT sensor) (12A697) is located in the engine air cleaner cover. When installing, use care not to damage plastic locking tabs. I hope this helps ...
...kia rio? On 2003 Kia Rio the knock sensor is located under the intake manifold and must be changed from underneath the car. If you remove the oil filter it is directly above it and is in clear view ...
...Kia Rio 2003 kia rio, It is located under the intake manifold. Get underneath the car, pull the oil filter...it is right above it and in clear view with the oil filter out of the way. The connector ...
Where is the IAT sensor on a 2007 Kia Rio? A picture would be great. The IAT is built into the MAF sensor, which is right behind the air filter in the air intake hose
...Kia Rio - Faulty Rear Heated Oxygen Sensor Bank 1 - Rear Heated Oxygen Sensor Bank 1 harness is open or shorted - Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection - Inappropriate ...
...kia rio The error code given in the data sheet is Intake air temperature (IAT) sensor - high input and the probable cause is Wiring open circuit/short to positive, earth wire defective, IAT sensor, ...
...rio kia On 2003 Kia Rio the knock sensor is located under the intake manifold and must be changed from underneath the car. If you remove the oil filter it is directly above it and is in clear view ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions